Specifying Vlans To Trunk - Avaya 2330 Manual

Interface mode configuration

Specifying VLANs to trunk

You can configure a trunk link to carry all the VLANs that exist on the device. You can also
selectively add VLANs to and remove VLANs from a trunk link. Use the procedures in this
section to specify the VLANs to add or remove from a trunk link.
Adding all VLANs to a trunk link
Use the procedure in this section to add all VLANs to a trunk link.
Procedure steps
1. To access configuration mode, enter:
2. To select an interface, enter:
3. To add all VLANs to the selected trunk link, enter: switchport trunk allowed
Removing all VLANs from a trunk link
Use the procedure in this section to remove all VLANs from a trunk link.
Procedure steps
1. To access configuration mode, enter:
2. To select an interface, enter:
3. To remove all VLANs from the selected trunk link, enter:
Adding a specified VLAN to a trunk link
Use the procedure in this section to selectively add VLANs to a trunk link.
Procedure steps
1. To access configuration mode, enter:
86 Configuration — Layer 2 Ethernet
configure terminal
interface [range] ethernet <slot/port>
vlan all
configure terminal
interface [range] ethernet <slot/port>
switchport trunk remove vlan all
Comments? infodev@avaya.com
July 2013