Avaya 2330 Manual page 151

3. To configure the hello time interval, enter:
Table 72: Variable definitions
<time value>
Restoring the default hello time value
Use the procedure in this section to restore the hello time value to the default setting (2
seconds).
Procedure steps
1. To access configuration mode, enter:
2. To access the bridge command context, enter:
3. To restore the default hello time interval, enter:
Table 73: Variable definitions
<time value>
Configuration — Layer 2 Ethernet
bridge
hello-time <time value>
Variable
configure terminal
bridge
no hello-time <time value>
Variable
Configuring Common Spanning Tree
Value
The interval, expressed in seconds, between
BPDU exchanges. The default value is 2
seconds. Valid values are 1 to 10 seconds.
Value
The hello time interval currently configured.
The default value is 2 seconds. Valid values
are 1 to 10 seconds.
July 2013 151