Configuring The Speed Of An Interface - Avaya 2330 Manual

Configuring the speed of an interface

Use the procedure in this section to configure the speed of an Ethernet interface.
Procedure steps
1. To access configuration mode, enter:
2. To select an interface, enter:
3. To configure the speed, enter:
Table 38: Variable definitions
{10 | 100 | 1000 | auto}
{half_duplex | full_duplex}
<slot/port>
Configuration — Layer 2 Ethernet
configure terminal
interface ethernet <slot/port>
speed {10|100|1000|auto} mode {half_duplex|full_duplex}
Variable
Configuring the speed of an interface
Value
Specifies the speed of the port. The default
value is auto.
Specifies the operating mode for the port.
The default value is half_duplex.
Specifies the slot and port numbers that
identify the port for configuration. For
example, 6/1.
July 2013 81