Configuring Link Types - Avaya 2330 Manual

Procedure steps
1. To access configuration mode, enter:
2. To access the bridge command context, enter:
3. To restore the default maximum age time, enter:
Table 77: Variable definitions
<time value>

Configuring link types

Use the procedures in this section to configure the link type.
Procedure steps
1. To access configuration mode, enter:
2. To select an Ethernet interface, enter:
3. To access the Spanning Tree command context, enter:
4. To specify the link type, enter:
Table 78: Variable definitions
<slot/port>
<type>
Configuration — Layer 2 Ethernet
configure terminal
bridge
no max-age <time value>
Variable
configure terminal
interface ethernet <slot/port>
spanning-tree
link-type <type>
Variable
Configuring Common Spanning Tree
Value
The maximum age time that is currently
configured. The default value is 20 seconds.
Valid values are 6 to 40 seconds.
Value
The slot and port numbers that identify the
port on which you configure the link type. For
example, 7/1.
Specifies the link type. Valid values are point-
to-point and shared. The default value is
point-to-point.
July 2013 155