In Program - Toshiba strata DK8 Installation Instructions Manual

PROGRAMMINGPROCEDURES-INSTRUCTIONS/SYSTEMRECORDS
SECTION lOO-816-302
MARCH1993
PROGRAM 20
DATA INTERFACE UNIT (DIU) PORT CONFIGURATION
Select = Logical Port Number that is connected to I Button/LEDs 1 - 5 defines data port type;
PDIU-DS or to DKT with PDWDI(2). -
Port Number
q%iidJ
I-- Button/LEDs 17 - 20 assigns data port to
III
security group.
III
Port Number
UL-I
Port Number Port Number
L-u uu
1 1 Group2 . 1 Included
I
18
17
16
Data Security Not
Group 3 Included
Data Security
Not
Group 1 Included
I I I
06 1 1 DTR Pulse With5 1 No DTR
18
17
Data Security
Group 3
Data Securitv
Not
Included
Not
I G-r ---- '
lo"0 1
I
Included I
16
06
05
04
03
02
DTR Pulse With5 No DTR
Data Release
Pulse
Auto Pause3 No Auto
Behind PBX Pause
PDIU-DS PDIU-Dl(2)6
Connected Connected
PDIU-DS to
PDIU-DS to other
Modem
type DCE or DTE
Connection
AT Commands AT Dial
and Result Codes Command Onlv
I I I
01 DIU
No DIU
Connected Connected
I
PDIU-DS PDIU-DI(2)6
Connected Connected
PDIU-DS to PDIU-DS to other
Modem
type DCE or DTE
Connection
AT Commands AT Dial
and Result Codes Command Only
DIU No DIU
Connected
Connected
NOTES
1. For more information, see the instructions preceding the record sheets. Copy this page if more than three D/Us are installed.
2. Initialized data: LED 17 ON, all others OFF.
3. Auto pause will be inserted after a Centrex
or PBX access code is dialed by a DIU: CO line must be assigned in Program
42-O and must have access code assigned in Program 42 (1 - 8). Pause time is determined by Program 12-3. A pause will
also be inserted after the DK CO line access code is dialed (by the DIU) in all cases if LED 05 is turned on.
4. DlUs can connect to any digital circuit in the Base Unit and on the PDKUZ and KCDU, but it can only connect to Circuits 1
- 7on the PDKUl.
5. If a PDIU-DS is connected to a modem, turn LED 06 ON to cause the modem to disconnect the line when the user presses
the Data Release button. Modem should be sent AT Command 'AT & 02" so it can recognize DTR pulse, and the PDIU-DS
SWI-2 switch must be off (in the up position). This feature is for outgoing modem calls only-DTR will not pulse on incoming
modem calls. Always change the modem escape sequence from "+ + +" to some other character using the "ATSZ=-"
command; this allows AT commands to be sent to the modem or DIU independently.
6. The PDIU-DI connects to IOOO-series Digital Telephones, and the PDIU-Dl2 connects to ZOOO-series Digital Telephones.
2-60