Toshiba strata DK8 Installation Instructions Manual page 239

PROGRAMMINGPROCEDURES-INTRODUCTION
SECTION lOO-816-301
MARCH1993
TABLE 1-D
INITIALIZATION PROGRAM 92
INITIALIZING SPEED DIAL NUMBERS, VM ID CODES, CHARACTER MESSAGE MEMORY,
TIMED REMINDERS, DIGITAL TELEPHONE VOLUME, AND CALL FORWARD BACKUP MEMORY
Press...
Step
BUTTONS + LED keys
#
Action description
LCD RESPONSE . . .
I. Use an LCD digital or electronic telephone with programming template.
NO. OF STATION (10 - 29)
JAN 20 SUN
06:43
> _.
*#+#1*2*3
PROGRAM MODE
Enter programming mode.
3. SPKR 9 2 HOLD
PROGRAM = 92
Access Program 92. System beeps after
DATA STORE
SPKR button is pressed to indicate when to
enter program number.
$. SPKR
92 SELECT =
Prepare system for selection of programs to initialize.
For new system installation, always perform 5A - 5F.
Select one of the following:
5. A. 1 + LED keys 01 & 03
92 SELECT = 1
Clears station speed dial, voice mail ID codes, and LCD
EACH DIAL CLR
memos assigned to station speed dial numbers.
OR
B. 2 + LED keys 01 & 04
92 SELECT = 2
Clears system speed dial and LCD memos assigned to system speed
COMMON DIAL CLR
dial numbers.
OR
C. 3 + LED
keys 02 8103
92 SELECT = 3
Clears character message memory (station and system) and user
MSG CLR
name display.
OR
D. 4 + LED
keys 02 & 04
92 SELECT = 4
Clears timed reminders. TMR REMINDER CLR
OR
E.
5 + LED keys 01 & 05 92 SELECT = 5
Presets the Ring/Speaker, Mute Ring, and Intercom Tone/BGM, DKT VR INITIAL
volume levels of all digital telephones to approximately midrange.
OR
F.
9 + LED keys 03 & 04 92 SELECT = 9
Clears Call Forward Memory except Fixed Call Forward Memory.
BACK UP RAM CLR
6.
HOLD (LEDs turn off)
92 SELECT = (l-0)
Secure data in system programming.
Repeat
steps 4 -
DATA PROGRAMMED
6 until steps 5A - 5F are completed (see note).
7.
SPKR
92 SELECT =
Prepare system for another selection (go back to step
5), or exit Program 92 (continue with step 8).
8. # # HOLD
92 SELECT = ##
Secure Program 92 data in system memory.
DATA PROGRAMMED
9.
SPKR
PROGRAM =
Exit Program 92. Enter another program number, or exit programming
mode (go to step IO). System beeps to indicate it's exiting Program 92.
IO.
# # HOLD
NO. OF STATION (10 - 29)
Exit programming mode.
JAN 20 SUN
06:58
NOTE:
If the call forward memory was cleared, cycle system power after Step 6, if it is required to reset telephone call
forward LCD displays or call forward button LED indications.
l-9