Toshiba strata DK8 Installation Instructions Manual page 293

PROGRAMMINGPROCEDURES-INSTRUCTIONS/SYSTEMRECOROS
SECTION 100-816-302
MARCH1993
PROGRAM 92
INITIALIZING SPEED DIAL NUMBERS, VM IO CODES CHARACTER MESSAGE MEMORY, TIMED
REMINDERS, DIGITAL TELEPHONE VOLUME, AND CALL FORWARD BACKUP RAM
more data
L Enter programming mode
END _1 L EXIT
SELECT = (as below)
Program 92
programming
mode
Clears Station Speed Dial, Voice Mail ID Codes,
and LCD memos assigned to Station Speed Dial numbers.
Clears System Speed Dial and LCD memos assigned to
System Speed Dial numbers.
Clears Character Message Memory (Station and System)
and user Name/Number display.
Clears Timed Reminders.
Sets speaker volume level to approximately mid-range for intercom
tone/BGM, busy override tone (muted ring), and ringing on all
digital telephones.4
Clears Call Forward Memory and Call Forward
indications on telephones.
NOTES:
1. IMPORTANT: It is mandatory to complete all parts of Program 92 at every
new system install. If Program 92 is not completed, certain feature opera-
tions may cause erratic system behavior.
2. Use the instructions in Table 1-D (Section 100-816-301) to clear this data.
3.
Program 92-9 does not affect Fixed Call Forward settings.
4. Program 92-5 does not affect digital telephone handset/headset receiver
volume levels. To set off-hook handset/headset receiver volume levels
individually for each digital telephone, see Program 30, L EDs 12 and 13.
5. Power "OFF" and "ON" is required to clear telephone LCD Call Forward
Displays and Call Forward button LEDs. Call Forward memory is cleared
when Program 92-9 is run, even if system power is not cycled.
WARNING!
Running this program will erase customer data.
2-45