Toshiba strata DK8 Installation Instructions Manual page 234

PROGRAMMING PROCEDURES-INTRODUCTION
SECTION 100-816-301
MARCH 1993
TABLE I-B
MULTIDIMENSIONAL PROGRAM: PROGRAM 30
(STATION CLASS OF SERVICE)
Press...
Step
BUTTONS + LED keys
&
Artinn dncrrintinn
LCD RESPONSE . . .
rr
I ,"Ll"l I """"l ,y-'L,v, I
1.
Use an LCD electronic or digital telephone.
NO.OF STATION (10 - 29)
Make sure the programming button strip template is
JAN 20
SUN
06:43
installed on the programming telephone (see
Paragraph 3.24).
2. *#*#1*2*3
PROGRAM MODE
Enter programming mode.
3. SPKR 3 0 HOLD
PROGRAM = 30
Access Program 30. System beeps after SPKR
DATA STORE
button is pressed to indicate a program number may
be entered.
4. SPKR
30 SELECT =
Prepare system for a port number selection.
5.
0 0 - 19 (0 0 - 0 9 for DK8) 30 SELECT = (00 - 19)
Enter the logical port number where the station being
defined is connected. Use two digits, followed by a #
key. A range of ports can be entered as specified in the
record sheet.
6.
LED keys 01 - 20
LED keys 01 - 20 activate features for each station port
or port range. Make the following selections by turning
the appropriate led key ON or OFF for each item (01 -
20) for each port, as marked on the system record
sheet:
LED 01 ON: Speakerphone Enabled
LED 02 ON: Microphone Key Lock Enabled
LED 03 ON: Microphone ON at Start of Call
LED 04 ON: Not Used
LED 05 ON: Speed Dial Allowed
LED 06 ON: Automatic Busy Redial Access Enabled
LED 07 ON: OCA/Busy Override Automatic
LED 08 ON: Forced Account Code Enabled
LED 09 ON: Toll Restriction Override Code Revision
Authority
LED 10 ON: DISA Security Code Change Allowed
LED 11 ON: Dial Pulse (DTMF Off) for Standard
Telephone
1-4