Toshiba strata DK8 Installation Instructions Manual page 400

To Program Speed Dial Names
and Numbers:
1, Press the Redial button,
then the Speed Dial button.
2. Dial the desired speed dial
code.
Press SDS or * if your telephone is not equipped with a Speed Dial
button.
[,n" SPEED DIAL ]
3. Press the Mode button
I""
4. Enter the name or memo (12
character maximum - refer to
Recording a Message for
method).
The name will appear on the top line of the LCD as you enter it.
5. Press the Mode button The number will appear on the bottom line of the LCD as you enter it
6. Enter the desired telephone
number (20 digits maximum).
7. Press the Redial button to
record data in memory.
6. Repeat steps 2-7 to enter
more memos.
To Dial a Speed Dial Number:
1, Press the Mode button when
telephone is idle.
The LCD displays "MODE NO.?"
2. DialENN (NN=lO-49
or80-89).
The speed dial number appears with name or memo. Personal speed
dial code numbers are 10 - 49, and system numbers, stored from station
10 only, are 60 - 99.
NN = Speed Dial Code. (IO-49 station) or (60-99 system station 10
only)
NOTE:
A station must be enabled via system programming for LCD message
memory.
If a name was previously stored on this code, it will display on the top line
of the LCD.
3. Press the Page button to
scan the directory for the
appropriate number/memo.
4. Press any available CO
button.
5. The number is dialed.
To Check a Speed Dial Number:
I. Press Mode 8 when
telephone is idle.
2. Dial a 2-digit speed dial
number.
3. Press the Page bunon to
scan the directory for the
appropriate number/memo.
Personal speed dial number (10 - 49) or system number (60 - 99).
If the number is longer than 16 digits, a "+" will appear in the far right
corner of the display. Press the Scroll button to display the remaining
digits.
TIMED REMINDERS WITH MEMO
This feature allows five separate messages (memos) to be set at each
LCD station. These messages will be displayed at the times (hour and
minute) set by the station user. They can either be displayed just once or
repeated on a daily basis.
To Set a Timed Reminder with
Memo:
1. Press the
Intercom
button.
2. Dial a 3.digit reminder
number (8 0 5 - 6 0 9).
The 3-digit reminder number may be 605 - 609.
3. Enter the desired time for the
The message time must be in 24-hour clock format (i.e., HHMM).
message to be displayed.
4. Dial 0 if the message is to be
repeated every day, or 1 if it is
a one-time message only.
4-8
4-9