Toshiba strata DK8 Installation Instructions Manual page 233

PROGRAMMINGPROCEDURES-INTRODUCTION
SECTION 100-816-301
MARCH1993
TABLE 1 -A
SIMPLE PROGRAM: PROGRAM 33
(STATION HUNTING)
Press...
Step
BUTTONS + LED keys
#
Action description LCD RESPONSE . . .
1. Use an LCD digital or electronic telephone. NO. OF STATION (10 - 29)
Make sure the programming button strip template is
JAN 20
SUN
06:43
installed on the programming telephone (see
Paragraph 3.24).
2. *#*#1*2*3
Enter programming mode.
PROGRAM MODE
3. SPKR 3 3 HOLD
Access Program 33. System beeps after SPKR key
PROGRAM = 33
is pressed to indicate program number may be entered.
DATA STORE
4. SPKR
Prepare the system for a station port selection.
33 SELECT =
5.
0 0 - 1 9 (0 0 - 0 9 for DK8)
Select the logical port number of the "Hunt From" station. 33 SELECT = too - lg)
Up to two digits followed by the # key, or a range of ports
HUNT To =
can be entered as specified on the record sheet.
6.
0 0 - 19 (0 0 - 0 9 for DK8)
Enter the logical port number of the "Hunt To" point, as
33 SELECT = (00 - 19)
recorded on the system record sheet. Press LED key 01
HUNT TO = (00 - 19)
to delete a digit from Hunt To point ports.
7.
HOLD 33 SELECT = (00 - 19)
Secure data in system programming.
DATA PROGRAMMED
8.
SPKR
33 SELECT =
Prepare system for another selection (go back to
step 5) or exit Program 33 (continue with step 9).
9.
# # HOLD 33 SELECT = ##
Secure Program 33 data in system memory.
DATA PROGRAMMED
IO. SPKR
PROGRAM =
Exit Program 33. Enter another program number or
exit programming mode (go to step 11).
Speaker beeps to indicate it is exiting Program 33.
11.
# # HOLD
NO. OF STATION (10 - 29)
Exit programming mode.
JAN 20 SUN
06:58
1-3