Program Toshiba
1725-36145-001_D.doc
The FCN [number] and LINE [number] labels represent the key
sequence on the handset mapped to the corresponding key on the
desk set.
The handset function menu default settings are shown in the table
below; these may be changed as described above in Function Menu
Programming. Some of these functions (Mute, Redial, Forward, etc.)
are activated by softkeys or
6000 and SpectraLink 8020/8030 Wireless Telephones.
FCN + 1
MUTE
FCN + 3
REDIAL
FCN + 5
FWD
FCN + 7
PICK
FCN + 9
EXIT MENUS
Station features
Perform the necessary system programming using a 20-button LCD
digital or electronic telephone connected to Port 005. All or a group of
handsets can be programmed at one time by entering a range of ports.
•
Use Program 30 and Program 31 to designate Station Class of
Service features for the handset. If the handset has no speaker be
sure to set these features as follows:
Speakerphone Enabled – Off
Mic on at Start of Call - Off
Handsfree Disabled
Paging Zone Off
•
Use Program 32 to designate Automatic Preference for the
handset, if desired.
•
Use Program 33 to designate the "Hunt to" port number or range
of numbers for the handset, if desired.
Use Program 40 to designate CO Line Access, if necessary. This
•
may need to be done if the ports assigned to the handsets are new
(i.e. not previously initialized).
menu options on the SpectraLink
FCN
FCN + 2
CNF/XFR
FCN + 4
MSG
FCN + 6
SPEED
FCN + 8
PAGE
Interface Implementation
15