Peku Installation Procedure - Toshiba strata DK8 Installation Instructions Manual

INSTALLATION-OK 16 KSU & PCB
SECTION 100-816-205
MARCH 1993
TABLE 5-B
PEKUCONTROLSANOINTERFACECONNECTORS
CONTROL/INDICATOR/
CONNECTOR (Figure 5-13)
Off-hook Call
Announce PI 0
Off-hook Call
Announce P20
Off-hook Call
Announce P40
Off-hook Call
Announce P50
Off-hook Call
Announce P60
DSS/EKT DSS Console/
Electronic Telephone
SW1 Switch
BGM source connection
W5 Jumper Wire
TYPE OF COMPONENT
1 O-pin connector
1 O-pin connector
1 O-pin connector
1 O-pin connector
1 O-pin connector
Two-position slide switch
White jumper wire
DESCRIPTION
interface connector for optional Off-hook
Call Announce subassembly
connector (used in conjunction with P20,
P40, P50, and P60).
Interface connector for optional Off-hook
Call Announce subassembly
connector (used in conjunction with PIO,
P40, P50, and P60).
Interface connector for optional Off-hook
Call Announce subassembly
connector (used in conjunction with PlO,
P20, P50, and P60).
Inter-face connector for optional Off-hook
Call Announce subassembly
connector (used in conjunction with Pl 0,
P20, P40, and P60).
Interface connector for optional Off-hook
Call Announce subassembly
connector (used in conjunction with PIO,
P20, P40, and P50).
Configures PEKU for operation with either
an HDSS console or electronic
telephones.
When cut, configures PEKU for BGM
source connection.
2) Cut the W5 (BGM) jumper wire on the PEKU
PCB.
3) Refer to Peripherals Installation, Section
IOO-
816-207,
for installation procedures for BGM
connection.
8.15 External Amplifier Configuration.
The PEKU
does not have to be configured to support an
external amplifier. However, the system must be
programmed for one; see Paragraph 8.40. See
Peripherals Installation, Section
100-816-207,
for
external amplifier installation instructions.
8.20 PEKU Installation Procedure
8.21 Install the PEKU in accordance with the fol-
lowing steps:
1) Remove the PCB from its protective
packaging.
2) Ensure the PEKU has been configured for the
appropriate hardware options (refer to Para-
graph 8.10).
3) Insert the PEKU into the appropriate slot (refer
to Paragraph 5.22), and apply firm, even
5-19