Removing Rear Axle (Cabin Model) - Kubota M8540 Workshop Manual

Hide thumbs Also See for M8540:

Table of Contents

M8540, M9540, WSM

(2) Removing Rear Axle (CABIN Model)

Removing Rear Axle Assembly

1. Remove the cylinder support (2).

2. Support the cabin and remove the cabin mounting bolt (1).

3. Remove the rear axle case mounting screws and nuts.

4. Support the rear axle case with nylon lift strap and hoist.

5. Separate the rear axle case from transmission case.

• Be sure to support the rear axle and make sure the balance

for support position.

• Hoist up and support the rear axle under neath as shown

(When reassembling)

• Apply liquid gasket (Three Bond 1206C or equivalent) to joint

face of the rear axle case and transmission case, after eliminate

the water, oil and stuck liquid gasket.

• Be sure to assemble the cabin mount as shown figure.

Cabin mounting bolt and

nut (M14, 7T)

Tightening torque

Rear axle case mounting

screw and nut

(1) Cabin Mounting Bolt

124 to 147 N·m

12.6 to 15.0 kgf·m

91.2 to 108 lbf·ft

197 to 225 N·m

20.0 to 23.0 kgf·m

145 to 166 lbf·ft

(2) Cylinder Support

KiSC issued 09, 2008 A

Table of Contents