Rear Wheels - Kubota M8540 Workshop Manual

M8540, M9540, WSM

(2) Rear Wheels

Tread (a)
420/85R30 –
460/85R30 –
420/85R34 –
180/70R34 –
1488 mm
23.1-26
58.58 in.
(1) Rear Wheel Mounting Nut
(2) Rear Disc Mounting Nut
Rear tread width can be adjusted as shown with the standard
equipped tires.
To change the tread width
1. Remove the wheel rim and / or disc mounting bolts.
2. Change the position of the rim and disc (right and left) to the
desired position, and tighten the bolts.
IMPORTANT
• Always attach wheels as shown in the figure.
• If not attached as illustrated, transmission parts may be
damaged.
• When re-fitting or adjusting a wheel, tighten the bolts to the
following torques then recheck after driving the tractor 200
m (200 yards) and thereafter according to service interval.
(Refer to "[5] CHECK POINTS OF EVERY 50 HOURS" at
"7. CHECK AND MAINTENANCE" in this section.)
Tightening
torque
A
1504 mm
59.21 in.
1546 mm
60.87 in.
1503 mm
59.17 in.
1503 mm
59.17 in.
–
(3) Rear Wheel Disc
(4) Rear Wheel Rim
Rear wheel mounting
nut
Fear disc mounting nut
(Both steel disc and cast
iron disc)
B C
1594 mm
62.76 in.
1552 mm
61.10 in.
1599 mm
62.95 in.
1599 mm
62.95 in.
–
(a) Tread
G-75
G GENERAL
343 to 401 N·m
M18 35.0 to 41.0 kgf·m
254 to 297 lbf·ft
259.9 to 304.0 N·m
M16 26.5 to 31.0 kgf·m
191.7 to 224.2 lbf·ft
W1082792
D
1707 mm
67.20 in.
1752 mm
68.98 in.
1695 mm
66.73 in.
1695 mm
66.73 in.
–
KiSC issued 09, 2008 A