Kubota M8540 Workshop Manual page 463

M8540, M9540, WSM
Position Feedback Rod and Draft Feedback Rod
1. Tap out the roll pin (4), remove the position feedback rod (1) with
position feedback lever (3) and washer (7).
2. Remove the draft feedback rod (2) with draft feedback lever (5)
and key (8).
3. Remove the stopper (6).
(When reassembling)
• Adjust the position and feedback rod length to the factory
specifications.
Position feedback rod
Factory spec.
length
Draft feedback rod
Factory spec.
length
(1) Position Feedback Rod
(2) Draft Feedback Rod
(3) Position Feedback Lever
(4) Roll Pin
Draft Spool Lever and Position Spool Lever
1. Push out the draft feedback shaft (2) and position feedback shaft
(1).
2. Push out the draft shaft (4) and position shaft (5).
3. Remove the draft spool lever (6).
4. Remove the control valve (3) then remove the position spool
lever (7).
(When reassembling)
• Fix the with groove side (9) on the draft spool lever (6) and
shorter side (8) on the position spool lever (7) face to the
hydraulic operating lever side.
• Be sure to fix the O-rings to the control valve and apply grease to
them.
(1) Position Feedback Shaft
(2) Draft Feedback Shaft
(3) Control Valve
(4) Draft Shaft
(5) Position Shaft
(6) Draft Spool Lever
8-S26
HYDRAULIC SYSTEM
210 mm
8.3 in.
272 mm
10.7 in.
(5) Draft Feedback Lever
(6) Stopper
(7) Washer
(8) Key
W1021825
(7) Position Spool Lever
(8) Shorter Side
(9) Groove
a : Push Out Direction
W1022053
KiSC issued 09, 2008 A