Rear Axle - Kubota M9000DT-M Workshop Manual Supplement

M9000DT-M, WSM
Drop Axle Case
1. Remove the drop axle case (2), (3) mounting screw and nut.
2. Separating the drop axle case 1 (2) from drop axle case 2 (3).
3. Remove the 23T gear assembly (4) and 24T gear assembly (5).
(When reassembling)
• Apply liquid gasket (Three Bond 1216 or equivalent) to joint face
of the drop axle case 1 (2) and drop axle case 2 (3).
IMPORTANT
• Reassembling 24T gear assembly is belleville (6) position as
showing in the figure.
Drop axle case mounting
screw
Tightening torque
Drop axle case mounting
M12 grade 9 nut
(1) With 80 in. Wide Axle Spacer
(Option)
(2) Drop Axle Case 1
(3) Drop Axle Case 2
Rear Axle Nut
1. Fix the rear axle on the repair table or set to the rear wheel.
2. Remove the stake on the rear axle nut (1).
3. Remove the rear axle nut (1) with a rear axle nut wrench 92 (3).
(See page MG-6.)
4. Tap out the rear axle (2).
(When reassembling)
• Replace the rear axle nut (1) with a new one, and stake if firmly
after tightening.
Tightening torque Rear axle nut
(1) Rear Axle Nut

(2) Rear Axle

M4-S2
REAR AXLE
77.5 to 90.2 N·m
7.9 to 9.2 kgf·m
57.1 to 66.5 ft-lbs
103.0 to 117.7 N·m
10.5 to 12.0 kgf·m
76.0 to 86.8 ft-lbs
(4) 23T Gear Assembly
(5) 24T Gear Assembly
(6) Belleville
W1011030
441.3 to 539.4 N·m
45.0 to 55.0 kgf·m
325.5 to 397.8 ft-lbs
(3) Rear Axle Nut Wrench 92
W1011325
KiSC issued 04, 2006 A