Kubota M8540 Workshop Manual page 411

M8540, M9540, WSM
Steering Support Under Cover
1. Remove the steering support under cover (1).
(1) Steering Support Under Cover
Shuttle Cable and Oil Pipes
1. Disconnect the shuttle cable (3).
2. Disconnect the power steering delivery hose 1 (4) and 2 (5) from
power steering controller.
3. Disconnect the controller pipe (6) and oil cooler pipe retaining nut
(1).
4. Remove the master cylinder delivery pipe joint screw (2).
(When reassembling)
• Be sure to assemble the power steering delivery hose to original
position.
• After assembling the power steering controller, be sure to adjust
the shuttle lever "Neutral" position, refer to "4. CHECKING AND
ADJUSTING" at "3. TRANSMISSION" section.
Power steering delivery
hose 1 and 2
Controller pipe retaining
nut
Tightening torque
Master cylinder delivery
pipe joint screw
Oil cooler pipe retaining
nut
(1) Oil Cooler Pipe Retaining Nut
(2) Master Cylinder Delivery Pipe Joint
Screw
(3) Shuttle Cable
7-S6
STEERING
W1014598
22.6 to 27.5 N·m
2.3 to 2.8 kgf·m
16.6 to 20.3 lbf·ft
49.0 to 68.6 N·m
5.0 to 7.0 kgf·m
36.2 to 50.6 lbf·ft
29.4 to 34.3 N·m
3.0 to 3.5 kgf·m
21.7 to 25.3 lbf·ft
49.0 to 68.6 N·m
5.0 to 7.0 kgf·m
36.2 to 50.6 lbf·ft
(4) Power Steering Delivery Hose 1
(5) Power Steering Delivery Hose 2
(6) Controller Pipe
W1010629
KiSC issued 09, 2008 A