Kubota M8540 Workshop Manual page 548

Hide thumbs Also See for M8540:

Table of Contents

M8540, M9540, WSM

Reassembling the Brush

1. Fit the brush with its sliding face in the clockwise direction when

viewed from front.

• Be sure to keep the 2 brushes deep in the brush holder.

Otherwise the rotor and the rear section can not be fitted

into position.

• Use a 4 mm hex. wrench to push the brushes into place.

• Using a pin-pointed (2 mm) punch, keep the brushes from

popping out.

2. Match the tally line of the front section with that of the rear

3. Tighten the 4 screws, and draw out the pin-pointed punch out of

the brush holder.

Bearing at Slip Ring Side

1. Lightly secure the rotor (1) with a vise to prevent damage, and

remove the bearing (2) with a puller (3).

ELECTRICAL SYSTEM

KiSC issued 09, 2008 A

Chapters

Table of Contents