Kubota M8540 Workshop Manual page 614

M8540, M9540, WSM
Inner Cover (R.H.)
1. Remove the hand accelerator lever grip (10).
2. Remove the range gear shift lever grip (1).
3. Remove the main shift lever grip (2).
4. Remove the auxiliary control lever grip (4).
5. Remove the PTO control lever grip (5).
6. Remove the position control lever grip (7) and draft control lever
grip (8).
7. Pull out the switch board (16).
8. Disconnect the 5P connector (11) from front wiper switch.
9. Disconnect the 3P connector (white) (13) from front working light
switch and 3P connector (white) (12) from 4WD switch.
10.Disconnect the 3P connector (blue) (14) from rear working light
switch.
11.Remove the inner cover R.H. (6).
12.Disconnect the 2P connector (16) from cigar lighter and remove
the inner cover 1 (R.H.) (6).
(1) Range Gear Shift Lever Grip
(2) Main Shift Lever Grip
(3) Parking Brake Lever 1
(4) Auxiliary Control Lever Grip
(5) PTO Switch
(6) Inner Cover (R.H.)
(7) Position Control Lever Grip
(8) Draft Control Lever Grip
(9) Inner Cover 2
(10) Hand Accelerator Lever Grip
Removing Heater Hoses
1. Disconnect the heater hoses (1) and (2).
2. Pull out the heater hoses (1) and (2) from the bottom of the cabin.
3. Take out the heater hoses (1) and (2).
(When reassembling)
• When connecting the heater hose with A/C unit, hose should be
put into the A/C unit pipe more than 30 mm (1.2 in.).
• Be sure to fix the heater hoses (1) and (2) to the original position.
Note the inlet hose and outlet hoses.
(1) Heater Hose 1
10-S50
(11) 5P Connector (Front Wiper Switch)
(12) 3P Connector (Rear Wiper Switch)
(13) 3P Connector
(Front Working Light Switch)
(14) 3P Connector
(Rear Working Light Switch)
(15) Beacon Light Switch
(16) Switch Board
(17) 2P Connector (Cigar Lighter)
(18) 3P Connector (PTO Switch)
W1034733
(2) Heater Hose 2
W1030250
KiSC issued 09, 2008 A
CABIN