Kubota M8540 Workshop Manual page 275

M8540, M9540, WSM
(3) Separating Transmission Case
Shuttle Wire Cable
1. Remove the shuttle wire cable (1).
2. Remove the clutch wire cable (2).
(1) Shuttle Wire Cable
Steering Support Unit
1. Unscrew the steering support screws (1).
2. Remove the steering support unit (2) as shown photo.
(1) Steering Support Screw
Separating Clutch Housing Case from Engine
1. Remove the clutch housing mounting screws and nuts.
2. Separate the clutch housing case.
(When reassembling)
• Apply molybdenum disulphide (Three Bond 1901 or equivalent)
to spline of input shaft.
• Apply liquid gasket (Three Bond 1211, 1141 or equivalent) to the
seam of engine and clutch housing.
Clutch housing mounting
Tightening torque
screw and nut (M14, 7T)
Separating Clutch Housing Case from Transmission Case
1. Remove the transmission case mounting screws and nuts.
2. Separate the clutch housing case from transmission case.
(When reassembling)
• Apply liquid gaskets (Three Bond 1206C or equivalent) to joint
face.
Transmission case
Tightening torque
mounting screw and nut
3-S31
TRANSMISSION
(2) Clutch Wire Cable
W1026838
(2) Steering Support Unit
W1027056
124 to 147 N·m
12.6 to 15.0 kgf·m
91.2 to 108 lbf·ft
W1012254
124 to 147 N·m
12.6 to 15.0 kgf·m
91.2 to 108 lbf·ft
W1012424
KiSC issued 09, 2008 A