Disassembling And Assembling; Hydraulic Shuttle Valve And Solenoid Valve Assembly; Removing Fuel Tank (Rops Model); Removing Fuel Tank (Cabin Model) - Kubota M8540 Workshop Manual

M8540, M9540, WSM

5. DISASSEMBLING AND ASSEMBLING

[1] HYDRAULIC SHUTTLE VALVE AND SOLENOID VALVE ASSEMBLY

(1) Removing Fuel Tank (ROPS Model)

(2) Removing Fuel Tank (CABIN Model)

Draining Transmission Fluid and Fuel
1. Refer to "7. CHECK
LUBRICANTS, FUEL AND COOLANT" at "G. GENERAL"
section.
Rear Wheel (L.H.) and Fender (L.H.)
1. Place the disassembling stand under the transmission case.
2. Remove the rear wheel (2).
3. Place the disassembling stand under the rear axle case.
4. Remove the fender (1).
(When reassembling)
Tightening torque Rear wheel mounting nut
(1) Fender
Fuel Tank
1. Remove the auxiliary step (3).
2. Disconnect the wire harness from fuel level sensor (1).
3. Remove the fuel filling port screw.
4. Remove the fuel hose and overflow hose.
5. Remove the fuel tank (2).
(1) Fuel Level Sensor
(2) Fuel Tank
Draining Transmission Fluid and Fuel
1. Refer to "7. CHECK
LUBRICANTS, FUEL AND COOLANT" at "G. GENERAL"
section.
Fuel Filling Port and Auxiliary Step
1. Remove the fuel filling port mounting screw (1).
2. Remove the auxiliary step (2).
(1) Fuel Filling Port Mounting Screw
3-S15
TRANSMISSION
AND MAINTENANCE" and "4.
343.2 to 393.3 N·m
35.0 to 40.1 kgf·m
253.2 to 290.0 lbf·ft
(2) Rear Wheel
(3) Auxiliary Step
AND MAINTENANCE" and "4.
(2) Auxiliary Step
KiSC issued 09, 2008 A
W1012355
W1016895
W1017026
W1015022
W1015076