Control Valve - Kubota M8540 Workshop Manual

Hide thumbs Also See for M8540:

Table of Contents

M8540, M9540, WSM

[4] CONTROL VALVE

Removing Control Valve

1. Remove the E-shaped stopper (2).

2. Remove the control valve mounting screws.

3. Remove the control valve (1).

• Do not loosen adjusting section at the end of the spool

unless necessary.

(When reassembling)

• Be sure to fit the O-rings.

Control valve mounting

Tightening torque

Factory spec.

Adjusting Spool Joint

1. Measure the length (L).

2. If the measurement is not within the factory specifications, loosen

the lock nut (4) and adjust by the spool link (3).

(1) Control Valve

(2) E-shaped Stopper

(3) Spool Link

HYDRAULIC SYSTEM

19.6 to 23.5 N·m

2.0 to 2.4 kgf·m

14.5 to 17.4 lbf·ft

85.8 to 86.2 mm

3.38 to 3.39 in.

(4) Lock Nut

KiSC issued 09, 2008 A

Table of Contents