Checking Mode - Kubota M8540 Workshop Manual

M8540, M9540, WSM

(2) Checking Mode

Checking Mode
1. Turn the key switch to "ON" position.
2. Press the PTO/Hour meter select switch (1) and traveling speed
select switch (2) more than 2 seconds.
3. Each time the PTO/Hour meter select switch (1) is pressed, the
code number changes in order of [1] → [2] → [3] → [4] → [1] with
flashing. The code number display as a table below.
4. Turn the key switch to "OFF" position to exit.
NOTE
• To check the engine revolution, enter the checking mode
under running the engine.
• When enter the checking mode under running the engine,
code 3 display the generating voltage of alternator.
No. Contents
1 Fuel sensor voltage
Coolant temperature sensor
2
voltage
3 Battery voltage
4 Engine revolution
(1) PTO/Hour Meter Select Switch
(2) Traveling Speed Select Switch
(3) LCD Monitor
9-S23
ELECTRICAL SYSTEM
Condition Displayed unit
F to E V
−30 to 120 °C
V
(−4 to 248 °F)
– V
Idling to max. n/min
(A) Procedure to enter checking mode
(B) Procedure to select code number
of checking contents
W1024533
KiSC issued 09, 2008 A