Kubota M8540 Workshop Manual page 332

M8540, M9540, WSM
Planetary Gear
1. Tap the roll pin (1) into the planetary gear shaft (3).
2. Draw out the planetary gear shaft (3), and remove the planetary
gear (2).
3. Tap out the roll pin from the planetary gear shaft.
(When reassembling)
• Apply transmission fluid to the inner surface of planetary gear (2).
• Tap in the roll pin (1) as shown in the figure.
(1) Roll Pin
(2) Planetary Gear
Rear Axle
1. Remove the external circlip (1).
2. Tap out the rear axle (2) half way.
3. Remove the ball bearing (3) and external circlip (4) from rear
axle.
4. Tap out the rear axle (2).
5. Tap out the ball bearing (5) and oil seal (6) together.
(1) External Circlip
(2) Rear Axle
(3) Ball Bearing
4-S7
REAR AXLE
(3) Planetary Gear Shaft
W1012932
(4) External Circlip
(5) Ball Bearing
(6) Oil Seal
W1013143
KiSC issued 09, 2008 A