Tightening Torques - Kubota M8540 Workshop Manual

M8540, M9540, WSM

3. TIGHTENING TORQUES

Tightening torques of screws, bolts and nuts on the table below are especially specified.
(For general use screws, bolts and nuts : Refer to "5. TIGHTENING TORQUES" at "G. GENERAL" section.)
Tie-rod end lock nut
Front axle rocking force adjusting lock nut
Power steering hose retaining nut
Bracket mounting nut
Bracket mounting screw
Front wheel mounting nut (M16)
Tie-rod end slotted nut
Tie-rod joint lock nut
Knuckle arm mounting screw (M12)
Bevel gear case mounting screw (M16, 9T)
Front wheel case support mounting screw (M16, 9T)
Front wheel case cover mounting screw
Front wheel mounting stud bolt (M16)
Differential case cover mounting screw (M8, USB)
Item N·m
167.7 to 196.1
98.1 to 147.1
22.6 to 27.5
123.6 to 147.1
166.7 to 196.1
259 to 304
156.9 to 176.5
166.7 to 196.1
77.5 to 90.2
259.9 to 304.0
259.9 to 304.0
48.1 to 55.9
130.4 to 152.0
29.4 to 34.3
6-S4
FRONT AXLE
kgf·m lbf·ft
17.1 to 20.0 123.7 to 144.7
10.0 to 15.0 72.3 to 108.5
2.3 to 2.8 16.6 to 20.3
12.6 to 15.0 91.1 to 108.5
17.0 to 20.0 123.0 to 144.7
26.5 to 31.0 191.7 to 224.2
16.0 to 18.0 115.7 to 130.2
17.0 to 20.0 123.0 to 144.7
7.9 to 9.2 57.1 to 66.5
26.5 to 31.0 191.7 to 224.2
26.5 to 31.0 191.7 to 224.2
4.9 to 5.7 35.4 to 41.2
13.3 to 15.5 96.2 to 112.1
3.0 to 3.5 21.7 to 25.3
W1012736
KiSC issued 09, 2008 A