Disassembling And Assembling; Separating Rear Axle; Removing Rear Axle (Rops Model) - Kubota M8540 Workshop Manual

M8540, M9540, WSM

4. DISASSEMBLING AND ASSEMBLING

[1] SEPARATING REAR AXLE

(1) Removing Rear Axle (ROPS Model)

Removing Rear Axle Assembly
1. Refer to the "5. DISASSEMBLING AND ASSEMBLING" at "3.
TRANSMISSION" section.
2. Remove the cylinder support (1).
3. Remove the rear axle case mounting screws and nuts.
4. Support the rear axle case with nylon lift strap and hoist.
5. Separate the rear axle case from transmission case.
(When reassembling)
• Apply liquid gasket (Three Bond 1206C or equivalent) to joint
face of the rear axle case and transmission case, after eliminate
the water, oil and stuck liquid gasket.
Rear axle case mounting
Tightening torque
screw and nut
(1) Cylinder Support
4-S4
REAR AXLE
197 to 225 N·m
20.0 to 23.0 kgf·m
145 to 166 lbf·ft
W1012123
KiSC issued 09, 2008 A