Brake Piston - Kubota M8540 Workshop Manual

Hide thumbs Also See for M8540:

Table of Contents

M8540, M9540, WSM

(5) Brake Piston

• Separating rear axle case from transmission case, refer to "4. DISASSEMBLING AND ASSEMBLING" at "4.

REAR AXLE" Section.

Brake Pedal (CABIN Model)

1. Remove the pedal shaft support (1).

2. Remove the master cylinder rod pins (3).

3. Unhook the springs (2).

4. Draw out the brake pedals (4).

(When reassembling)

• Apply grease to the pedal shaft.

• After reassembling the brake pedal, be sure to adjust the

brake pedal free travel.

(1) Pedal Shaft Support

Brake Piston

1. Remove the bleeder.

2. Remove the brake piston with compressed air. (Slowly inject an

air from bleeder hole (1).)

(When reassembling)

• Replace the brake seal 1 and 2 with new one.

• Install the brake seal so as not to twist.

• Take care not to enter the foreign matter into the seal groove of

inside brake case.

• When installing the brake piston, apply silicon grease to the

brake seals, and tap it in evenly and lightly using a soft hammer.

(1) Bleeder Hole

(2) Brake Piston

(4) Brake Pedal

(3) Brake Seal 1

(4) Brake Seal 2

KiSC issued 09, 2008 A

Table of Contents