Kubota M8540 Workshop Manual page 606

M8540, M9540, WSM
Preparation 8
1. Disconnect the position control rod (2) and draft control rod (1).
2. Disconnect the select cable (6).
3. Disconnect the range gear shift rod (5).
4. Disconnect the main gear shift rod (4).
5. Remove the gear lock parking brake cable (7).
6. Remove the brake hose (3).
NOTE
• After assembling check the speed change lever movement
and adjust them if necessary.
• After assembling check the hydraulic control system. (Refer
to "4. CHECKING AND ADJUSTING" at "8. HYDRAULIC
SYSTEM" section.)
(When reassembling)
• Be sure to bleed the air from hydraulic brake line.
Length (L1)
Factory spec.
(Draft control rod)
Length (L2)
Factory spec.
(Position control rod)
Length (L3)
Factory spec.
(Main shift rod)
Length (L4)
Factory spec.
(Range shift rod)
Tightening torque Brake hose retaining nut
(1) Position Control Rod
(2) Draft Control Rod
(3) Brake Hose
(4) Main Gear Shift Rod
Dismounting Cabin
1. Remove the cabin mounting all screws and nut (1).
2. Set the cabin dismounting tool (2) to the cabin.
3. Dismounting the cabin from tractor body.
(When reassembling)
Cabin mounting screw and
Tightening torque
nut
(1) Cabin Mounting Nut
10-S42
Approx. 178 mm
7.01 in.
Approx. 183 mm
7.20 in.
Approx. 211 mm
8.31 in.
Approx. 279 mm
11.0 in.
16.0 to 24.0 N·m
1.6 to 2.4 kgf·m
11.8 to 17.7 lbf·ft
(5) Range Gear Shift Rod
(6) Select Cable
(7) Gear Lock Parking Brake Cable
W1013471
124 to 147 N·m
12.6 to 15.0 kgf·m
91.2 to 108 lbf·ft
(2) Cabin Dismounting Tool
W1029973
KiSC issued 09, 2008 A
CABIN