Step
1.
Enter system view.
2.
Enter aggregate interface
view.
3.
Set the minimum number of
Selected ports for the
aggregation group.
4.
Set the maximum number of
Selected ports for the
aggregation group.
Setting the expected bandwidth for an aggregate interface
Step
1.
Enter system view.
2.
Enter aggregate interface
view.
3.
Set the expected bandwidth
for the interface.
Configuring an edge aggregate interface
When you configure an edge aggregate interface, follow these restrictions and guidelines:
This configuration takes effect on only the aggregate interface corresponding to a dynamic
•
aggregation group.
Link-aggregation traffic redirection does not operate correctly on an edge aggregate interface. For
•
more information about Link-aggregation traffic redirection, see
redirection."
To configure an edge aggregate interface:
Command
system-view
•
Enter Layer 2 aggregate
interface view:
interface bridge-aggregation
interface-number
•
Enter Layer 3 aggregate
interface view:
interface route-aggregation
interface-number
link-aggregation selected-port
minimum number
link-aggregation selected-port
maximum number
Command
system-view
•
Enter Layer 2 aggregate
interface view:
interface bridge-aggregation
interface-number
•
Enter Layer 3 aggregate
interface or subinterface view:
interface route-aggregation
{ interface-number |
interface-number.subnumber }
bandwidth bandwidth-value
51
Remarks
N/A
N/A
By default, the minimum number of
Selected ports for the aggregation
group is not specified.
By default, the maximum number of
Selected ports for an aggregation
group is 32.
Remarks
N/A
N/A
By default, the expected
bandwidth (in kbps) is the interface
baud rate divided by 1000.
"Enabling link-aggregation traffic