HP 6125XLG Configuration Manual page 39

Step
2. Enable MAC address
moving notifications.
3. Set a threshold for MAC
address moves sourced
from an interface within a
detection interval.
4. Set a MAC address move
suppression interval.
5. Enter interface view.
6. Enable MAC address
move suppression.
7. Return to system view.
8. Enable ARP fast update
for MAC address moves.
Command
mac-address notification mac-move
[ interval interval-value ]
mac-address notification mac-move
suppression threshold threshold-value
mac-address notification mac-move
suppression interval interval-value
•
Enter Layer 2 Ethernet interface view:
interface interface-type
interface-number
•
Enter Layer 2 aggregate interface
view:
interface bridge-aggregation
interface-number
mac-address notification mac-move
suppression
quit
mac-address mac-move fast-update
29
Remarks
By default, MAC address
moving notifications are
disabled.
If you do not specify a detection
interval, the default setting of 1
minute is used. The interval
interval-value option is available
in Release 2406P03 and later
versions.
After you execute this command:
•
If the device is configured
with the snmp-agent trap
enable mac-address
command, the system sends
SNMP notifications to the
SNMP module.
•
If the device is not
configured with the
snmp-agent trap enable
mac-address command, the
system sends log messages
to the information center
module.
The default setting is 3.
This task is available in Release
2406P03 and later versions.
The default setting is 30
seconds.
N/A
By default, MAC address move
suppression is disabled.
N/A
For the MAC address move
suppression feature to take
effect, you must perform this
task. For more information about
the ARP fast update feature, see
Layer 3—IP Services
Configuration Guide.
By default, ARP fast update for
MAC address moves is
disabled.