Configuring Basic Settings Of An Ethernet Interface - HP 6125XLG Configuration Manual

Step
7. Split the 40-GE interface into
four 10-GE interfaces.
8. Reboot the device.
Combining four split 10-GE interfaces into a 40-GE interface
If you need higher bandwidth, you can combine the four split 10-GE interfaces into a 40-GE interface.
To combine four split 10-GE interfaces into a 40-GE interface:
Step
1. Enter system view.
2. Enter the view of any 10-GE
interface split from a 40-GE
interface.
3. Combine the four 10-GE
interfaces into a 40-GE
interface.
4. Reboot the device.

Configuring basic settings of an Ethernet interface

Configuring an Ethernet interface
Step
1. Enter system view.
Command
using tengige
N/A
Command
system-view
interface interface-type
interface-number
using fortygige
N/A
Command
system-view
3
Remarks
By default, a 40-GE interface is not
split and operates as a single
interface.
The 10-GE interfaces split from a
40-GE interface support the same
configuration and attributes as
common 10-GE interfaces, except
that they are numbered in a different
way.
After creating the four 10-GE
interfaces, the system removes the
40-GE interface.
A 40-GE interface split into four
10-GE interfaces must use a
dedicated 1-to-4 cable.
Remarks
N/A
N/A
By default, a 40-GE interface is not
split and operates as a single
interface.
After creating the 40-GE interface,
the system removes the four 10-GE
interfaces.
After you combine the four 10-GE
interfaces, replace the dedicated
1-to-4 cable with a dedicated
1-to-1 cable or a 40-GE transceiver
module. For more information
about the cable or transceiver
module, see the installation guides.
Remarks
N/A