Displaying And Maintaining Vlans - HP 6125XLG Configuration Manual

Step
5. Enter interface view.
6. Configure the port link
type as hybrid.
7. Assign the hybrid port to
the specified
protocol-based VLANs.
8. Associate the hybrid port
with the specified
protocol-based VLAN.

Displaying and maintaining VLANs

Execute display commands in any view.
Task
Display VLAN interface information.
Display information about IP subnet-based
VLANs that are associated with the specified
ports.
Display information about IP subnet-based
VLANs.
Display information about protocol-based
VLANs that are associated with the specified
ports.
Display information about protocol-based
VLANs.
Display VLAN information.
Display hybrid ports or trunk ports on the
device.
Command
•
Enter Layer 2 Ethernet
interface view:
interface interface-type
interface-number
•
Enter Layer 2 aggregate
interface view:
interface
bridge-aggregation
interface-number
port link-type hybrid
port hybrid vlan vlan-id-list
{ tagged | untagged }
port hybrid protocol-vlan vlan
vlan-id { protocol-index [ to
protocol-end ] | all }
Command
display interface [ vlan-interface ] [ brief [ down ] ]
display interface [ vlan-interface [ interface-number ] ] [ brief
[ description ] ]
display ip-subnet-vlan interface { interface-type
interface-number1 [ to interface-type interface-number2 ] |
all }
display ip-subnet-vlan vlan { vlan-id1 [ to vlan-id2 ] | all }
display protocol-vlan interface { interface-type
interface-number1 [ to interface-type interface-number2 ] |
all }
display protocol-vlan vlan { vlan-id1 [ to vlan-id2 ] | all }
display vlan [ vlan-id1 [ to vlan-id2 ] | all | dynamic |
reserved | static ]
display port { hybrid | trunk }
143
Remarks
•
The configurations made in Layer 2
Ethernet interface view apply only to
the port.
•
The configurations made in Layer 2
aggregate interface view apply to the
aggregate interface and its
aggregation member ports. If the
system fails to apply the configurations
to the aggregate interface, it stops
applying the configurations to
aggregation member ports. If the
system fails to apply the configurations
to an aggregation member port, it
skips the port and moves to the next
member port.
By default, all ports are access ports.
By default, a hybrid port is an untagged
member of the VLAN to which the port
belongs when its link type is access.
By default, a port is not associated with
any protocol-based VLANs.