Source IP address.
•
•
Destination IP address.
Source MAC address.
•
Destination MAC address.
•
•
Source and destination IP addresses.
Source and destination MAC addresses.
•
To configure per-flow load sharing algorithm settings for Ethernet link aggregation:
Step
1.
Enter system view.
2.
Configure the load sharing
algorithm.
3.
Configure the load sharing
algorithm seed.
Enabling link-aggregation traffic redirection
Link-aggregation traffic redirection prevents traffic interruption.
When you shut down a Selected port in an aggregation group, this feature redirects traffic to other
Selected ports.
When you restart an IRF member device that contains Selected ports, this feature redirects traffic to other
IRF member devices.
Configuration restrictions and guidelines
When you enable ink-aggregation traffic redirection, follow these restrictions and guidelines:
•
Link-aggregation traffic redirection applies only to dynamic link aggregation groups and takes
effect on only known unicast packets.
To prevent traffic interruption, enable link-aggregation traffic redirection on devices at both ends of
•
the aggregate link.
To prevent packet loss that might occur at a reboot, do not enable spanning tree together with
•
link-aggregation traffic redirection.
•
Link-aggregation traffic redirection does not operate correctly on an edge aggregate interface.
Configuration procedure
To enable link-aggregation traffic redirection:
Step
1.
Enter system view.
Command
system-view
link-aggregation global
load-sharing algorithm
algorithm-number
link-aggregation global
load-sharing seed seed-number
Command
system-view
56
Remarks
N/A
By default, algorithm 0 is used.
By default, algorithm seed 0 is
used.
Remarks
N/A