HP 6125XLG Configuration Manual page 58

Step
9. Set the short LACP timeout
interval (3 seconds) on the
interface.
Configuring a Layer 3 dynamic aggregation group
Step
1. Enter system view.
2. Set the system LACP priority.
3. Create a Layer 3 aggregate
interface and enter Layer 3
aggregate interface view.
4. Configure the aggregation
group to operate in dynamic
aggregation mode.
5. Exit to system view.
6. Assign an interface to the
specified Layer 3 aggregation
group.
Set the LACP operating mode
7.
on the interface.
8. Configure the port priority for
the interface.
9. Configure the short LACP
timeout interval (3 seconds)
on the interface.
Command
lacp period short
Command
system-view
lacp system-priority system-priority
interface route-aggregation
interface-number
link-aggregation mode dynamic
quit
a. Enter Layer 3 Ethernet
interface view:
interface interface-type
interface-number
b. Assign the interface to the
specified Layer 3
aggregation group:
port link-aggregation
group number
•
Set LACP to operate in passive
mode:
lacp mode passive
•
Set LACP to operate in active
mode:
undo lacp mode
link-aggregation port-priority
port-priority
lacp period short
48
Remarks
By default, the long LACP timeout
interval (90 seconds) is adopted by
the interface. The peer sends
LACPDUs slowly.
Remarks
N/A
By default, the system LACP priority
is 32768.
Changing the system LACP priority
might affect the aggregation state
of the ports in the dynamic
aggregation group.
When you create a Layer 3
aggregate interface, the system
automatically creates a Layer 3
static aggregation group
numbered the same.
By default, an aggregation group
operates in static aggregation
mode.
N/A
Repeat these two sub-steps to
assign more Layer 3 Ethernet
interfaces to the aggregation
group.
By default, LACP is operating in
active mode.
The default setting is 32768.
By default, the long LACP timeout
interval (90 seconds) is adopted by
the interface. The peer sends
LACPDUs slowly.