Performing Basic Lldp Configuration; Enabling Lldp - HP 6125XLG Configuration Manual

Tasks at a glance
(Optional.)
(Optional.)
(Optional.)

Performing basic LLDP configuration

Enabling LLDP

To make LLDP take effect on specific ports, you must enable LLDP both globally and on these ports.
To use LLDP together with OpenFlow, you must enable LLDP globally on OpenFlow switches. To prevent
LLDP from affecting topology discovery of OpenFlow controllers, HP recommends that you disable LLDP
on ports of OpenFlow instances. For more information about OpenFlow, see OpenFlow Configuration
Guide.
To enable LLDP:
Step
1. Enter system view.
2. Enable LLDP globally.
3. Enter Layer 2/Layer 3
Ethernet interface view,
management Ethernet
interface view, or Layer
2/Layer 3 aggregate
interface view.
4. Enable LLDP.
Configuring CDP compatibility
Configuring DCBX
Configuring LLDP trapping and LLDP-MED trapping
Command
system-view
lldp global enable
interface interface-type interface-number
lldp enable
239
Remarks
N/A
By default:
•
If the switch starts up
with empty
configuration, LLDP is
disabled globally (initial
setting).
•
If the switch starts up
with the default
configuration file, LLDP
is enabled globally
(factory default).
For more information about
empty configuration and
the default configuration
file, see Fundamentals
Configuration Guide.
N/A
By default, LLDP is enabled
on a port.