Mvrp Configuration Example; Network Requirements; Configuration Procedure - HP 6125XLG Configuration Manual

MVRP configuration example

Network requirements

As shown in
VLAN 10 to MSTI 1, map VLAN 20 to MSTI 2, and map the other VLANs to MSTI 0.
Configure MVRP and set the MVRP registration mode to normal, so that Device A, Device B, Device C,
and Device D can register and deregister dynamic VLANs and keep identical VLAN configuration for
each MSTI.
When the network is stable, set the MVRP registration mode to fixed on the port of Device B connected
to Device A, so that dynamic VLANs on the port will not be deregistered.
Figure 50 Network diagram

Configuration procedure

Configuring Device A
# Enter MST region view.
<DeviceA> system-view
[DeviceA] stp region-configuration
Figure 50, create VLAN 10 on Device A and VLAN 20 on Device B. Configure MSTP, map
180