Qinq Implementations; Protocols And Standards - HP 6125XLG Configuration Manual

As shown in
and CE 3. The CVLANs of the two customers overlap. The service provider assigns SVLANs 3 and 4 to
customers A and B, respectively.
When a tagged Ethernet frame from CE 1 arrives at PE 1, the PE tags the frame with SVLAN 3. The
double-tagged Ethernet frame travels over the service provider network until it arrives at PE 2. PE 2
removes the SVLAN tag of the frame, and then sends the frame to CE 4.
Figure 52 Typical QinQ application scenario
VLANs 1 to 20
Customer
network B
PE 1
Customer
network A
VLANs 1 to 10

QinQ implementations

QinQ is enabled on a per-port basis. The link type of a QinQ-enabled port can be access, hybrid, or
trunk. The QinQ tagging behaviors are the same across these types of ports.
A QinQ-enabled port tags all incoming frames (tagged or untagged) with the PVID tag. If an incoming
frame already has one tag, it becomes a double-tagged frame. If the frame does not have any 802.1Q
tag, it becomes a frame tagged with the PVID.
QinQ provides the most basic VLAN manipulation method, which tags all incoming frames (tagged or
untagged) with the PVID tag. To perform advanced VLAN manipulations, use VLAN mapping (see
"Configuring VLAN
To use different SVLANs for different CVLAN tags, use one-to-two VLAN mapping.
•
To replace the SVLAN ID, CVLAN ID, or both IDs for an incoming double-tagged frame, configure
•
two-to-two VLAN mapping.
To set the 802.1p priority in SVLAN tags, configure a QoS policy as described in
•
802.1p priority in SVLAN

Protocols and standards

• IEEE 802.1Q, IEEE Standard for Local and Metropolitan Area Networks-Virtual Bridged Local Area
Networks
Figure 52, customer A has remote sites CE 1 and CE 4. Customer B has remote sites CE 2
CE 3
CVLAN B Data
SVLAN 4 CVLAN B
SVLAN 3 CVLAN A
CVLAN A Data
CE 1
mapping") or QoS policies. For example:
tags."
SVLAN 3
Data
Network
Data SVLAN 4
Service provider network
191
VLANs 1 to 10
CE 4
CVLAN A Data
CVLAN A Data
CVLAN B Data
CVLAN B Data
CE 2
VLANs 1 to 20
"Setting the
Customer
network A
PE 2
Customer
network B