Layer 3 Edge Aggregate Interface Configuration Example - HP 6125XLG Configuration Manual

[DeviceA] interface ten-gigabitethernet 1/1/7
[DeviceA-Ten-GigabitEthernet1/1/7] port link-aggregation group 1
[DeviceA-Ten-GigabitEthernet1/1/7] quit
2. Configure Device B in the same way Device A is configured. (Details not shown.)
Verifying the configuration
# Display detailed information about all aggregation groups on Device A.
[DeviceA] display link-aggregation verbose
Loadsharing Type: Shar -- Loadsharing, NonS -- Non-Loadsharing
Port Status: S -- Selected, U -- Unselected, I -- Individual
Flags: A -- LACP_Activity, B -- LACP_Timeout, C -- Aggregation,
D -- Synchronization, E -- Collecting, F -- Distributing,
G -- Defaulted, H -- Expired
Aggregate Interface: Route-Aggregation1
Aggregation Mode: Dynamic
Loadsharing Type: Shar
System ID: 0x8000, 000f-e267-6c6a
Local:
Port
--------------------------------------------------------------------------------
XGE1/1/5
XGE1/1/6
XGE1/1/7
Remote:
Actor
--------------------------------------------------------------------------------
XGE1/1/5
XGE1/1/6
XGE1/1/7
The output shows that link aggregation group 1 is a non-load-shared Layer 3 dynamic aggregation
group and it contains three Selected ports.

Layer 3 edge aggregate interface configuration example

Network requirements
As shown in
server starts a reboot. Ten-GigabitEthernet 1/1/5 and Ten-GigabitEthernet 1/1/6 must forward packets
correctly during the server's reboot process.
To meet this requirement, configure Layer 3 aggregate interface Route-Aggregation 1 on the device as
an edge aggregate interface.
Status Priority Oper-Key
S 32768
S 32768
S 32768
Partner Priority Oper-Key
1 32768
2 32768
3 32768
Figure 18, the device and the server are the two ends of a dynamic aggregate link. The
Flag
1 {ACDEF}
1 {ACDEF}
1 {ACDEF}
SystemID
1 0x8000, 000f-e267-57ad {ACDEF}
1 0x8000, 000f-e267-57ad {ACDEF}
1 0x8000, 000f-e267-57ad {ACDEF}
67
Flag