Configuring A Downlink Port; Displaying And Maintaining Pbb; Pbb Configuration Example; Network Requirements - HP 6125XLG Configuration Manual

Configuring a downlink port

On the BEB, frames from the customer network are mapped to a PBB VSI based on match criteria
configured on downlink ports. PBB frames from the PBBN are decapsulated in the corresponding PBB VSI.
They are forwarded out of the corresponding downlink ports based on their customer MAC addresses.
You can specify one or multiple downlink ports for a PBB VSI.
To configure a downlink port:
Step
1. Enter system view.
2. Enter Layer 2 Ethernet
interface view.
3. Create a service instance and
enter service instance view.
4. Configure match criteria.
5. Associate the service instance
with the specified PBB VSI.
For more information about the service-instance, encapsulation, and xconnect vsi commands, see MPLS
Command Reference.

Displaying and maintaining PBB

Execute display commands in any view and execute the reset command in user view.
Task
Display the PBB VSI uplink connection information.
Display MAC-in-MAC connection information.
Display MAC-in-MAC forwarding entries.
Display VSI information.
Clear the PBB VSI uplink connection information.

PBB configuration example

Network requirements

As shown in Figure 67:
Command
system-view
interface interface-type
interface-number
service-instance instance-id
encapsulation s-vid vlan-id
[ only-tagged ]
encapsulation { default | tagged |
untagged }
xconnect vsi vsi-name
[ access-mode { ethernet | vlan } ]
Command
display pbb connection
display l2vpn minm connection [ vsi vsi-name ]
display l2vpn minm forwarding [ vsi vsi-name ] [ slot
slot-number ]
display l2vpn vsi [ name vsi-name ] [ verbose ]
reset pbb connection [ bvlan vlan-id | interface
interface-type interface-number ] *
228
Remarks
N/A
N/A
By default, no service instance
exists on a port.
By default, no match criterion is
configured.
By default, a service instance is not
associated with any PBB VSI.