Vlan Transparent Transmission Configuration Example - HP 6125XLG Configuration Manual

# Configure VLAN 200 as the PVID of Ten-GigabitEthernet 1/1/7.
[PE1-Ten-GigabitEthernet1/1/7] port trunk pvid vlan 200
# Enable QinQ on Ten-GigabitEthernet 1/1/7.
[PE1-Ten-GigabitEthernet1/1/7] qinq enable
[PE1-Ten-GigabitEthernet1/1/7] quit
2. Configure PE 2:
# Configure Ten-GigabitEthernet 1/1/5 as a trunk port, and assign it to VLAN 200 and VLANs 30
through 90.
<PE2> system-view
[PE2] interface ten-gigabitethernet 1/1/5
[PE2-Ten-GigabitEthernet1/1/5] port link-type trunk
[PE2-Ten-GigabitEthernet1/1/5] port trunk permit vlan 200 30 to 90
# Configure VLAN 200 as the PVID of Ten-GigabitEthernet 1/1/5.
[PE2-Ten-GigabitEthernet1/1/5] port trunk pvid vlan 200
# Enable QinQ on Ten-GigabitEthernet 1/1/5.
[PE2-Ten-GigabitEthernet1/1/5] qinq enable
[PE2-Ten-GigabitEthernet1/1/5] quit
# Configure Ten-GigabitEthernet 1/1/6 as a trunk port, and assign it to VLAN 100 and VLAN
200.
[PE2] interface ten-gigabitethernet 1/1/6
[PE2-Ten-GigabitEthernet1/1/6] port link-type trunk
[PE2-Ten-GigabitEthernet1/1/6] port trunk permit vlan 100 200
# Set the TPID value in the SVLAN tags to 0x8200 on Ten-GigabitEthernet 1/1/6.
[PE2-Ten-GigabitEthernet1/1/6] qinq ethernet-type service-tag 8200
[PE2-Ten-GigabitEthernet1/1/6] quit
# Configure Ten-GigabitEthernet 1/1/7 as a trunk port, and assign it to VLAN 100 and VLANs 10
through 70.
[PE2] interface ten-gigabitethernet 1/1/7
[PE2-Ten-GigabitEthernet1/1/7] port link-type trunk
[PE2-Ten-GigabitEthernet1/1/7] port trunk permit vlan 100 10 to 70
# Configure VLAN 100 as the PVID of Ten-GigabitEthernet 1/1/7.
[PE2-Ten-GigabitEthernet1/1/7] port trunk pvid vlan 100
# Enable QinQ on Ten-GigabitEthernet 1/1/7.
[PE2-Ten-GigabitEthernet1/1/7] qinq enable
[PE2-Ten-GigabitEthernet1/1/7] quit
3. Configure the devices between PE 1 and PE 2:
# Set the MTU to a minimum of 1504 bytes for each port on the forwarding path of QinQ frames.
(Details not shown.)
# Configure all the ports on the forwarding path to allow frames from VLANs 100 and 200 to pass
through without removing the VLAN tag. (Details not shown.)

VLAN transparent transmission configuration example

Network requirements
As shown in Figure 54:
198