Layer 3 Dynamic Aggregation Configuration Example - HP 6125XLG Configuration Manual

Flags: A -- LACP_Activity, B -- LACP_Timeout, C -- Aggregation,
D -- Synchronization, E -- Collecting, F -- Distributing,
G -- Defaulted, H -- Expired
Aggregate Interface: Route-Aggregation1
Aggregation Mode: Static
Loadsharing Type: Shar
Port
--------------------------------------------------------------------------------
XGE1/1/5
XGE1/1/6
XGE1/1/7
The output shows that link aggregation group 1 is a non-load-shared Layer 3 static aggregation group
that contains three Selected ports.

Layer 3 dynamic aggregation configuration example

Network requirements
On the network shown in
Configure a Layer 3 dynamic aggregation group on both Device A and Device B.
•
Configure IP addresses and subnet masks for the corresponding Layer 3 aggregate interfaces.
•
Figure 17 Network diagram
Configuration procedure
1. Configure Device A:
# Create Layer 3 aggregate interface Route-Aggregation 1.
<DeviceA> system-view
[DeviceA] interface route-aggregation 1
# Set the link aggregation mode to dynamic.
[DeviceA-Route-Aggregation1] link-aggregation mode dynamic
# Configure an IP address and subnet mask for Route-Aggregation 1.
[DeviceA-Route-Aggregation1] ip address 192.168.1.1 24
[DeviceA-Route-Aggregation1] quit
# Assign Layer 3 Ethernet interfaces Ten-GigabitEthernet 1/1/5 through Ten-GigabitEthernet
1/1/7 to aggregation group 1.
[DeviceA] interface ten-gigabitethernet 1/1/5
[DeviceA-Ten-GigabitEthernet1/1/5] port link-aggregation group 1
[DeviceA-Ten-GigabitEthernet1/1/5] quit
[DeviceA] interface ten-gigabitethernet 1/1/6
[DeviceA-Ten-GigabitEthernet1/1/6] port link-aggregation group 1
[DeviceA-Ten-GigabitEthernet1/1/6] quit
Status Priority Oper-Key
S 32768 1
S 32768 1
S 32768 1
Figure 17, perform the following tasks:
66