Configuring An Aggregate Interface - HP A3100-8 v2 SI Configuration Manual

NOTE:
To guarantee a successful dynamic aggregation, make sure that the peer ports of the ports aggregated at
one end are also aggregated. The two ends can automatically negotiate the aggregation state of each
member port.
Follow these steps to configure a Layer 2 dynamic aggregation group:
To do...
Enter system view
Set the system LACP priority
Create a Layer 2 aggregate
interface and enter the Layer 2
aggregate interface view
Configure the aggregation group
to work in dynamic aggregation
mode
Exit to system view
Enter Layer 2 Ethernet interface
view
Assign the Ethernet interface to the
aggregation group
Assign the port an LACP priority
Set the LACP timeout interval on the
port to the short timeout interval (1
second)

Configuring an aggregate interface

Use the command...
system-view
lacp system-priority system-priority
interface bridge-aggregation
interface-number
link-aggregation mode dynamic
quit
interface interface-type
interface-number
port link-aggregation group
number
lacp port-priority port-priority
lacp period short
34
Remarks
—
Optional
By default, the system LACP priority
is 32768.
Changing the system LACP priority
might affect the aggregation state
of the ports in a dynamic
aggregation group.
Required
When you create a Layer 2
aggregate interface, the system
automatically creates a Layer 2
static aggregation group
numbered the same.
Required
By default, an aggregation group
works in static aggregation mode.
—
Required
Repeat these two steps to assign
more Layer 2 Ethernet interfaces to
the aggregation group.
Optional
By default, the LACP priority of a
port is 32768.
Changing the LACP priority of a
port might affect the aggregation
state of the ports in the dynamic
aggregation group.
Optional
By default, the LACP timeout
interval on a port is the long
timeout interval (30 seconds).