Configuration Procedure - HP 6125XLG Configuration Manual

Figure 37 Network diagram

Configuration procedure

1. Configure Device A:
# Create VLAN 100, and globally enable loop detection for the VLAN.
<DeviceA> system-view
[DeviceA] vlan 100
[DeviceA-vlan100] quit
[DeviceA] loopback-detection global enable vlan 100
# Configure Ten-GigabitEthernet 1/1/5 and Ten-GigabitEthernet 1/1/6 as trunk ports, and
assign them to VLAN 100.
[DeviceA] interface ten-gigabitethernet 1/1/5
[DeviceA-Ten-GigabitEthernet1/1/5] port link-type trunk
[DeviceA-Ten-GigabitEthernet1/1/5] port trunk permit vlan 100
[DeviceA-Ten-GigabitEthernet1/1/5] quit
[DeviceA] interface ten-gigabitethernet 1/1/6
[DeviceA-Ten-GigabitEthernet1/1/6] port link-type trunk
[DeviceA-Ten-GigabitEthernet1/1/6] port trunk permit vlan 100
[DeviceA-Ten-GigabitEthernet1/1/6] quit
# Configure the global loop protection action as shutdown.
[DeviceA] loopback-detection global action shutdown
# Set the loop detection interval to 35 seconds.
[DeviceA] loopback-detection interval-time 35
2. Configure Device B:
# Create VLAN 100.
<DeviceB> system-view
[DeviceB] vlan 100
[DeviceB–vlan100] quit
Device A
XGE1/1/5 XGE1/1/6
Device B
VLAN 100
Device C
130