HP 6125XLG Configuration Manual page 78

Figure 18 Network diagram
Configuration procedure
1. Configure the device:
# Create Layer 3 aggregate interface Route-Aggregation 1, and set the link aggregation mode to
dynamic.
<Device> system-view
[Device] interface route-aggregation 1
[Device-Route-Aggregation1] link-aggregation mode dynamic
# Configure an IP address and subnet mask for Layer 3 aggregate interface Route-Aggregation 1.
[Device-Route-Aggregation1] ip address 192.168.1.1 24
# Configure Layer 3 aggregate interface Route-Aggregation 1 as an edge aggregate interface.
[Device-Route-Aggregation1] lacp edge-port
[Device-Route-Aggregation1] quit
# Assign Layer 3 Ethernet interfaces Ten-GigabitEthernet 1/1/5 and Ten-GigabitEthernet 1/1/6
to aggregation group 1.
[Device] interface ten-gigabitethernet 1/1/5
[Device-Ten-GigabitEthernet1/1/5] port link-aggregation group 1
[Device-Ten-GigabitEthernet1/1/5] quit
[Device] interface ten-gigabitethernet 1/1/6
[Device-Ten-GigabitEthernet1/1/6] port link-aggregation group 1
[Device-Ten-GigabitEthernet1/1/6] quit
2. Configure the server as required. (Details not shown.)
Verifying the configuration
# Display detailed information about all aggregation groups on the device during the server's reboot
process.
[Device] display link-aggregation verbose
Loadsharing Type: Shar -- Loadsharing, NonS -- Non-Loadsharing
Port Status: S -- Selected, U -- Unselected, I -- Individual
Flags: A -- LACP_Activity, B -- LACP_Timeout, C -- Aggregation,
D -- Synchronization, E -- Collecting, F -- Distributing,
G -- Defaulted, H -- Expired
Aggregate Interface: Route-Aggregation1
Aggregation Mode: Dynamic
Loadsharing Type: NonS
System ID: 0x8000, 000f-e267-6c6a
Local:
Port
--------------------------------------------------------------------------------
XGE1/1/5
Status Priority Oper-Key
I 32768 1
Flag
{AG}
68