Protocols And Standards; Lldp Configuration Task List - HP 6125XLG Configuration Manual

Transmitting LLDP frames
An LLDP agent operating in TxRx mode or Tx mode sends LLDP frames to its directly connected devices
both periodically and when the local configuration changes. To prevent LLDP frames from overwhelming
the network during times of frequent changes to local device information, LLDP uses the token bucket
mechanism to rate limit LLDP frames. For more information about the token bucket mechanism, see ACL
and QoS Configuration Guide.
LLDP automatically enables the fast LLDP frame transmission mechanism in either of the following cases:
A new neighbor is discovered. A new LLDP frame is received and carries device information new to
•
the local device.
• The LLDP operating mode of the LLDP agent changes from Disable or Rx to TxRx or Tx.
With this mechanism, a specific number of LLDP frames are sent successively at a configurable fast
transmission interval to help LLDP neighbors discover the local device as soon as possible. Then, the
normal LLDP frame transmission interval resumes.
Receiving LLDP frames
An LLDP agent that is operating in TxRx mode or Rx mode examines the validity of TLVs carried in every
received LLDP frame. If the TLVs are valid, the LLDP agent saves the information and starts an aging timer.
When the TTL value in the Time to Live TLV carried in the LLDP frame becomes zero, the information ages
out immediately.

Protocols and standards

IEEE 802.1AB-2005, Station and Media Access Control Connectivity Discovery
•
• IEEE 802.1AB-2009, Station and Media Access Control Connectivity Discovery
ANSI/TIA- 1 057, Link Layer Discovery Protocol for Media Endpoint Devices
•
DCB Capability Exchange Protocol Specification Rev 1.00
•
DCB Capability Exchange Protocol Base Specification Rev 1.01
•
IEEE Std 802.1Qaz™-201 1, Media Access Control (MAC) Bridges and Virtual Bridged Local Area
•
Networks-Amendment 18: Enhanced Transmission Selection for Bandwidth Sharing Between Traffic
Classes

LLDP configuration task list

Tasks at a glance
Performing basic LLDP configuration:
•
(Required.)
•
(Optional.)
•
(Optional.)
•
(Optional.)
•
(Optional.)
•
(Optional.)
•
(Optional.)
•
(Optional.)
•
(Optional.)
Enabling LLDP
Configuring the LLDP bridge mode
Setting the LLDP operating mode
Setting the LLDP re-initialization delay
Enabling LLDP polling
Configuring the advertisable TLVs
Configuring the management address and its encoding format
Setting other LLDP parameters
Setting an encapsulation format for LLDP frames
238