Layer 2 Edge Aggregate Interface Configuration Example - HP 6125XLG Configuration Manual

Loadsharing Type: Shar -- Loadsharing, NonS -- Non-Loadsharing
Port Status: S -- Selected, U -- Unselected, I -- Individual
Flags: A -- LACP_Activity, B -- LACP_Timeout, C -- Aggregation,
D -- Synchronization, E -- Collecting, F -- Distributing,
G -- Defaulted, H -- Expired
Aggregate Interface: Bridge-Aggregation1
Aggregation Mode: Static
Loadsharing Type: Shar
Port
--------------------------------------------------------------------------------
XGE1/1/5
XGE1/1/6
Aggregate Interface: Bridge-Aggregation2
Aggregation Mode: Static
Loadsharing Type: Shar
Port
--------------------------------------------------------------------------------
XGE1/1/7
XGE1/1/8
The output shows that:
Link aggregation groups 1 and 2 are both load-shared Layer 2 static aggregation groups.
•
Each aggregation group contains two Selected ports.
•
# Display all the group-specific load sharing modes on Device A.
[DeviceA] display link-aggregation load-sharing mode interface
Bridge-Aggregation1 Load-Sharing Mode:
source-mac address
Bridge-Aggregation2 Load-Sharing Mode:
destination-mac address
The output shows that:
Link aggregation group 1 load shares traffic based on source MAC addresses.
•
Link aggregation group 2 load shares traffic based on destination MAC addresses.
•

Layer 2 edge aggregate interface configuration example

Network requirements
As shown in
starts a reboot. Ten-GigabitEthernet 1/1/5 and Ten-GigabitEthernet 1/1/6 must forward packets from
the server correctly during its reboot process.
To meet this requirement, configure Layer 2 aggregate interface Bridge-Aggregation 1 on the device as
an edge aggregate interface.
Status Priority Oper-Key
S 32768
S 32768
Status Priority Oper-Key
S 32768
S 32768
Figure 15, the device and the server are two ends of a dynamic aggregate link. The server
1
1
2
2
63