Configuring Load Sharing For Link Aggregation Groups; Setting Load Sharing Modes For Link Aggregation Groups - HP 6125XLG Configuration Manual

Step
3. Restore the default settings for the
aggregate interface.
Configuring load sharing for link aggregation
groups
This section explains how to configure load sharing modes for link aggregation groups and how to
enable local-first load sharing for link aggregation.

Setting load sharing modes for link aggregation groups

You can configure the global or group-specific load sharing mode. A link aggregation group
preferentially uses the group-specific load sharing mode. If no group-specific load sharing mode is
available, the group uses the global load sharing mode.
Setting the global link-aggregation load sharing mode
Step
Enter system view.
1.
2. Set the global
link-aggregation load
sharing mode.
Setting group-specific load sharing mode
Step
1. Enter system view.
2. Enter aggregate interface
view.
3. Set the load sharing mode
for the aggregation group.
Command
default
Command
system-view
link-aggregation global load-sharing
mode { destination-ip | destination-mac
| destination-port | ingress-port |
source-ip | source-mac | source-port } *
Command
system-view
•
Enter Layer 2 aggregate interface
view
interface bridge-aggregation
interface-number
•
Enter Layer 3 aggregate interface
view:
interface route-aggregation
interface-number
link-aggregation load-sharing mode
{ destination-ip | destination-mac |
source-ip | source-mac } *
54
Remarks
N/A
By default, the system
automatically chooses the global
link-aggregation load sharing
mode according to the packet
type.
Remarks
N/A
N/A
The default settings are the same
as the global load sharing mode.