HP 6125XLG Configuration Manual page 14

Step
2. Enter Ethernet interface
view.
3. Set the interface
description.
4. Set the duplex mode of
the Ethernet interface.
5. Set the port speed.
6. Configure the expected
bandwidth of the
interface.
7. Restore the default
settings for the Ethernet
interface.
8. Bring up the Ethernet
interface.
Configuring an Ethernet subinterface
Step
1. Enter system view.
2. Create an Ethernet
subinterface and enter
its view.
3. Set the subinterface
description.
4. Restore the default
settings for the Ethernet
subinterface.
5. Configure the expected
bandwidth for the
interface.
6. Bring up the Ethernet
subinterface.
Command
interface interface-type
interface-number
description text
duplex { auto | full }
speed { 1000 | 10000 | 40000
| auto }
bandwidth bandwidth-value
default
undo shutdown
Command
system-view
interface interface-type
interface-number.subnumber
description text
default
bandwidth bandwidth-value
undo shutdown
4
Remarks
N/A
The default setting is in the format of
interface-name Interface. For example,
Ten-GigabitEthernet1/1/5 Interface.
The default setting is auto for Ethernet
interfaces.
The default setting is auto for Ethernet
interfaces.
For more information, see Layer 2—LAN
Switching Command References.
By default, the expected bandwidth (in
kbps) is the interface baud rate divided by
1000.
N/A
By default, Ethernet interfaces are in up
state.
Remarks
N/A
N/A
The default setting is in the format of
interface-name Interface. For
example,
Ten-GigabitEthernet1/1/5.1
Interface.
N/A
By default, the expected bandwidth
(in kbps) is the interface baud rate
divided by 1000.
By default, Ethernet subinterfaces are
in up state.