Configuring The Lldp Bridge Mode; Setting The Lldp Operating Mode - HP 6125XLG Configuration Manual

Configuring the LLDP bridge mode

The following LLDP bridge modes are available:
• Service bridge mode—In service bridge mode, LLDP supports nearest bridge agents and nearest
non-TPMR bridge agents. LLDP processes the LLDP frames with destination MAC addresses for these
agents and transparently transmits the LLDP frames with other destination MAC addresses in the
VLAN.
Customer bridge mode—In customer bridge mode, LLDP supports nearest bridge agents, nearest
•
non-TPMR bridge agents, and nearest customer bridge agents. LLDP processes the LLDP frames with
destination MAC addresses for these agents and transparently transmits the LLDP frames with other
destination MAC addresses in the VLAN.
To configure the LLDP bridge mode:
Step
1. Enter system view.
2. Configure LLDP to operate
in service bridge mode.

Setting the LLDP operating mode

Step
1. Enter system view.
2. Enter Layer 2/Layer 3
Ethernet interface view,
management Ethernet
interface view, or Layer
2/Layer 3 aggregate
interface view.
Command
system-view
lldp mode service-bridge
Command
system-view
interface interface-type interface-number
240
Remarks
N/A
By default, LLDP operates in
customer bridge mode.
Remarks
N/A
N/A