HP 6125XLG Configuration Manual page 267

[SwitchA-Ten-GigabitEthernet1/1/6] lldp admin-status rx
[SwitchA-Ten-GigabitEthernet1/1/6] quit
2. Configure Switch B:
# Enable LLDP globally.
<SwitchB> system-view
[SwitchB] lldp global enable
# Enable LLDP on Ten-GigabitEthernet 1/1/5. (You can skip this step because LLDP is enabled on
ports by default.) Set the LLDP operating mode to Tx.
[SwitchB] interface ten-gigabitethernet 1/1/5
[SwitchB-Ten-GigabitEthernet1/1/5] lldp enable
[SwitchB-Ten-GigabitEthernet1/1/5] lldp admin-status tx
[SwitchB-Ten-GigabitEthernet1/1/5] quit
Verifying the configuration
# Verify that:
Ten-GigabitEthernet 1/1/5 of Switch A connects to a MED device.
•
• Ten-GigabitEthernet 1/1/6 of Switch A connects to a non-MED device.
Both ports operate in Rx mode, and they can receive LLDP frames but cannot send LLDP frames.
•
[SwitchA] display lldp status
Global status of LLDP: Enable
Bridge mode of LLDP: customer-bridge
The current number of LLDP neighbors: 2
The current number of CDP neighbors: 0
LLDP neighbor information last changed time: 0 days, 0 hours, 4 minutes, 40 seconds
Transmit interval
Fast transmit interval
Transmit credit max
Hold multiplier
Reinit delay
Trap interval
Fast start times
LLDP status information of port 1 [Ten-GigabitEthernet1/1/5]:
LLDP agent nearest-bridge:
Port status of LLDP
Admin status
Trap flag
MED trap flag
Polling interval
Number of LLDP neighbors
Number of MED neighbors
Number of CDP neighbors
Number of sent optional TLV
Number of received unknown TLV : 0
LLDP agent nearest-customer:
Port status of LLDP
: 30s
: 1s
: 5
: 4
: 2s
: 30s
: 4
: Enable
: RX_Only
: No
: No
: 0s
: 1
: 1
: 0
: 21
: Enable
257